Numerical simulation of mold filling in injection molding using a three-dimensional finite volume approach
From MaRDI portal
Publication:2764859
DOI10.1002/FLD.166zbMath1078.76564OpenAlexW2163070977MaRDI QIDQ2764859
Publication date: 2001
Published in: International Journal for Numerical Methods in Fluids (Search for Journal in Brave)
Full work available at URL: https://doi.org/10.1002/fld.166
Navier-Stokes equations for incompressible viscous fluids (76D05) Finite volume methods applied to problems in fluid mechanics (76M12)
Related Items (9)
Simulation of stress distribution near weld line in the viscoelastic melt mold filling process ⋮ Influence of flow-fiber coupling during mold-filling on the stress field in short-fiber reinforced composites ⋮ Extension of SPH to simulate non-isothermal free surface flows during the injection molding process ⋮ Filling of channels with a non-Newtonian fluid in the gravity field ⋮ Parallel three‐dimensional simulation of the injection molding process ⋮ Finite element modeling of the lost foam casting process tackling back‐pressure effects ⋮ An unstructured CVFEM and moving interface algorithm for non‐Newtonian Hele‐Shaw flows in injection molding ⋮ Experimental and numerical investigation of a viscoplastic carbopol gel injected into a prototype 3D mold cavity ⋮ Development of SPH for simulation of non-isothermal viscoelastic free surface flows with application to injection molding
Cites Work
- Unnamed Item
- Unnamed Item
- Unnamed Item
- Unnamed Item
- Volume of fluid (VOF) method for the dynamics of free boundaries
- FLAIR: Flux line-segment model for advection and interface reconstruction
- The ULTIMATE conservative difference scheme applied to unsteady one- dimensional advection
- A diagonally dominant second-order accurate implicit scheme
- Reconstructing volume tracking
- A method for capturing sharp fluid interfaces on arbitrary meshes
- A time-implicit filling algorithm
- Modelling merging and fragmentation in multiphase flows with SURFER
- Numerical simulation of flows encountered during mold-filling
- Numerical study of the turbulent flow past an airfoil with trailing edge separation
- Numerical Calculation of Time-Dependent Viscous Incompressible Flow of Fluid with Free Surface
- RIPPLE - A new model for incompressible flows with free surfaces
- Efficient mould filling simulation in castings by an explicit finite element method
This page was built for publication: Numerical simulation of mold filling in injection molding using a three-dimensional finite volume approach
