Third-order point contact approach for five-axis sculptured surface machining using non-ball-end tools. II: Tool positioning strategy

DOI10.1007/S11431-010-3184-4zbMath1380.70025OpenAlexW2049765087MaRDI QIDQ617247

Han Ding, LiMin Zhu, YouLun Xiong

Publication date: 21 January 2011

Published in: Science China. Technological Sciences (Search for Journal in Brave)

Full work available at URL: https://doi.org/10.1007/s11431-010-3184-4

zbMATH Keywords

cutter envelope surfacethird-order point contactcutter positioningnon-ball-end cutter

Mathematics Subject Classification ID

Kinematics of mechanisms and robots (70B15) Robot dynamics and control of rigid bodies (70E60)

Related Items (7)

A multi-dimensional tabu search algorithm for the optimization of process planning ⋮ Milling stability analysis using the spectral method ⋮ Kinematics constrained five-axis tool path planning for high material removal rate ⋮ Analytical modeling of geometric errors induced by cutter runout and tool path optimization for five-axis flank machining ⋮ On-line chatter detection using servo motor current signal in turning ⋮ A control algorithm for rapid movements near the radius compensation singularity in five-axis end milling ⋮ Kinematic generation of ruled surface based on rational motion of point-line

Cites Work

• Third-order point contact approach for five-axis sculptured surface machining using non-ball-end tools. I: Third-order approximation of tool envelope surface
• A machining potential field approach to tool path generation for multi-axis sculptured surface machining
• Multi-point tool positioning strategy for 5-axis mashining of sculptured surfaces

This page was built for publication: Third-order point contact approach for five-axis sculptured surface machining using non-ball-end tools. II: Tool positioning strategy